Issue a command that will enable EIGRP for IPv6 routing in R1, R2 and R3.Д®nable the EIGRP process on all routers and use 1 as the Autonomous System number. The IPv6 routing process is shutdown by default. R1(config)# ipv6 unicast-routing R2(config)# ipv6 unicast-routing R3(config)# ipv6 unicast-routing Step 2: Enable EIGRP for IPv6 routing on each router. Part 1: Configure EIGRP for IPv6 Routing Step 1: Enable IPv6 routing on each router. The EIGRP for IPv6 routing process uses a вЂњshutdownвЂќ feature.With EIGRP for IPv6, a router-id is required on each router or the routing process will not start.EIGRP for IPv6 is configured directly on the router interfaces.There are a few major differences between them:

You will also assign router IDs, configure passive interfaces, verify the network is fully converged, and display routing information using show commands.Д®IGRP for IPv6 has the same overall operation and features as EIGRP for IPv4. In this activity, you will configure the network with EIGRP routing for IPv6. Part 2: Verify IPv6 EIGRP for IPv6 Routing Scenario 6.4.3.4 Packet Tracer вЂ“ Configuring Basic EIGRP with IPv6 Routing Addressing Table Device

6.4.3.4 packet tracer answers pdf